Showing 4640–4650 of 10509 results

Use the LBP-1S lacer bar when lacing cables vertically or horizontally. Aluminum construction provides the ability to drill holes to attach tie saddles, mount electrical boxes, etc. This lacer bar can also be used to support the rear of equipment. 3/16” thick aluminum, 1/4” diameter rod with flattened ends.

Use the LBP-1.5 & LBP-1R4 when lacing small bundles or individual cables off the rear of equipment, patch panels and other components to relieve cable stress from the connections. Choose the appropriate offset based on the distance from the rear of equipment to the rackrail. 1/4” diameter rod with flattened ends.

These LBP-1.5R90 series offset lacer bars are similar to our other offset round lacer bars, but feature 90° bends to provide full-width support. Can also be used to provide clearance around components that extend past the rear rackrail (16-5/8” open width). 1/4” diameter rod with flattened ends.

Essex Horizontal Lacer Bars relieve cable stress from connections when lacing individual cables or small bundles. This assortment of cable management solutions was designed to fit perfectly in Essex racks and helps ensure that installed AV systems run reliably and are finished with a professional touch.

6” Wide Vertical Wire Grid Lace. Includes specific hardware for SNE Series and universal hardware for use in other racks.

6” Wide Vertical Wire Grid Lace. Includes specific hardware for SNE Series and universal hardware for use in other racks

84 Inch High, 1 Inch Wide Cable Lacer Strip For GRK Series Broadcast Rack. Includes 6 Pieces

Middle Atlantic Products IQBP-2 rack accessory Fan tray

28 3/4' D X 24-1/8” HChoose the IDF when rackmounting hubs, routers and other equipment overhead in warehouses, retail outlets or any larger, open location. Mounts to building truss or Unistrut® beams using 1/2” threaded rod, or directly to Unistrut beams. Includes safety lanyard. A great solution for distributed systems.Mounts to building truss or Unistrut® beam using threaded rods (not included)Can also mount directly to Unistrut® beamIncludes a safety lanyard to ensure a secure installationDual exhaust fans extend equipment lifeAluminum bottom plate for mounting wireless antennae, dome cameras, and moreMultiple UHF/VHF antenna knockouts on the bottom of the enclosureRack top includes four integral gland grommeted 4” cable pass-throughsStandard solid front and rear locking and latched doors with safety chainsStandard front and rear adjustable 10-32 threaded rackrail with numbered spaces

Removes hot air from smaller cabinets, credenzas, and lecterns