Showing 1950–1960 of 9438 results

"The RAM-202-400 consists of the small Tough-Claw base, double socket arm and round base adapter. The RAM Tough-Claw is the perfect mounting base for quick and easy tool-less installation and removal on round, square, odd shaped rails and bars. The Tough-Claw can be clamped on rails from 0.625"" - 1.5"" outer diameter. The round base adapter contains the industry standard universal AMPS hole pattern, which will connect to a large variety of RAM Mount and third party cradles. The mount is designed with a RAM 1.5"" diameter patented rubber ball and socket system that has adjustment points at both ends of the double socket arm; this allowing for almost infinite adjustment and perfect viewing angles."

RAM Mounts RAM-202 mounting kit

"The RAM-201-B, short double socket arm, has a socket at both ends that accommodates 1.5"" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and socket connection. This socket technology allows for almost infinite adjustment and perfect viewing angles."

"The RAM-200-1U includes a single socket that will accommodate 1.5"" balls and a 1/2"" NPT Female thread. This part will connect to 1/2"" NPT Male threads, including RAM-PA82XX rigid arms."

RAM Mounts RAM-162BU mounting kit

"The RAM-114DTMU deck and track flat surface base includes a socket compatible with RAM ROD and RAM-TUBE holders with a spline post. The RAM-114DTMU is designed to attach to Tite-Lok track systems with a 3.25"" width."

The RAM-111BT universal base has a short post connected at right angles to a flat 6.25 x 2 inch rectangular base. The base has many different combinations of pre-drilled holes which will match up to many electronic devices and mounts, including Marine GPS, CB Radios, Ham Radios, Gimbal Brackets and more. The small post on the base is designed to connect to the RAM-109 series arms. Included on the end of the post is a tightening knob for use when installed on the compatible RAM-109 series arm.

"The RAM-109V-4U consists of a 6"" long curved swing arm with open socket and vertical surface mounting base. There are two (2) pivoting points on the mount: one at the swing arm and base and one at the center of the open single socket. Each pivoting point allows a complete 360 degree rotation. The open socket will accommodate all RAM 1.5"" diameter ball component parts."

Proclip 855096 mounting kit

Proclip 213566 mounting kit