Showing 260–270 of 594 results

"The RAM-137BU, universal mounting plate, consists of a 1.5"" diameter rubber ball, connected at right angles to a flat 3"" x 11"" rectangular plate. The plate contains different combinations of pre-drilled holes which will match up to many electronic devices and mounts, including Marine GPS, CB Radios, Ham Radios, Gimbal Brackets and more."

RAM Mounts RAM-2-1U mounting kit

"The RAM-202PSAU, double sided adhesive disk, is designed to connect to any 2.5"" round base including the RAM-B-202U, RAM-202U or RAP-B-202U."

"The RAM-201-SU consists of a 1.5"" dia. ball compatible STANDARD LENGTH double socket arm, mixed combination Pin-Lock security nut and key knob. RAM Pin-Lock security solutions are designed to withstand the harshest environments where RAM Mounts are commonly used. With an emphasis on aesthetics and function, RAM security nuts/knobs are low profile and only add a small amount of additional bulk to your system when compared to the standard knob included. At a fraction of the cost of currently available keyed locking knobs, the additional peace of mind and tamper resistance comes at a very affordable price."

"The RAM-201, standard length double socket arm, has a socket at both ends that accommodates 1.5"" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and socket connection. This socket technology allows for almost infinite adjustment and perfect viewing angles."

RAM Mounts RAM-114FMU mounting kit

The RAM-101-BL locking mount consists of the short arm 1.5 inch diameter ball and socket system with universal round base ends. This mount is designed to be a universal mounting solution for both RAM and non-RAM designed products. Each plate includes a hole pattern that matches the standard AMPS four hole pattern and a three hole 120 degree hole pattern.

"The RAM-109-1AP is a Bent 6"" long Arm Extension for the RAM 109 series. This arm includes a 3"" long bolt, washers and tightening knob. This swing arm will connect directly to either the RAM-109H-B Horizontal Base or the RAM-109V-B Vertical Base. The 3"" bolt will allow the swing arm to connect to a RAM-109 base, and the other end of this mount will connect to either a second Swing Arm with 4"" Bolt RAM-109-1A or RAM-109-1ATU or a Rectangular Pivoting Plate RAM-111BT"

"The RAM-224-3U consists of a triple suction cup base with 1.5"" diameter ball. The RAM-224-3U is designed to have an extra strong hold on any smooth non-porous surface, but for best result, mount the RAM-224-3U on a glass or non-porous plastic surface."

RAM Mounts RAM-114RMU mounting kit