Showing 940–950 of 2883 results

Vent blockers are used to prevent the recirculation of hot air between top-mount fans and nearby vent openings. Vent blockers should be placed over the enclosure’s vents located on the upper front of the enclosure, upper sides, and upper rear door (depending on enclosure). This will ensure that heated enclosure air will be forced out through the top-mounted exhaust fans instead of re-circulating, keeping equipment cool.

Vent blockers are used to prevent the recirculation of hot air between top-mount fans and nearby vent openings. Vent blockers should be placed over the enclosure’s vents located on the upper front of the enclosure, upper sides, and upper rear door (depending on enclosure). This will ensure that heated enclosure air will be forced out through the top-mounted exhaust fans instead of re-circulating, keeping equipment cool.

Vent blockers are used to prevent the recirculation of hot air between top-mount fans and nearby vent openings. Vent blockers should be placed over the enclosure’s vents located on the upper front of the enclosure, upper sides, and upper rear door (depending on enclosure). This will ensure that heated enclosure air will be forced out through the top-mounted exhaust fans instead of re-circulating, keeping equipment cool.

Cooling panel with control and display; 50 CFM at 24 dBThe two rackspace Ultra Quiet Fan Panel System provides smart cooling and monitoring to ensure a reliable installation in areas where fan noise is not an option, including boardrooms, classrooms, offices, houses of worship, etc. Thermostatic, proportional speed DC fan control ensures ultra quiet operation by varying fan speed based on enclosure temperature. Overtemp notification, local and remote, offers additional operation monitoring. A unique feature of the system provides notification in the event of fan failure via a local display or remote signal to an external alarm device. 50 CFM cooling capacity Digital processor varies fan speed based on enclosure temperature for ultra quiet operation Front panel rack temperature and alert display provides instant system status On-board digital processor monitors rack temperature via external sensor Local and remote notification of over temperature and fan fault can be sent to a control systemCooling panel rated 50 CFM at 24 dBIntelligent thermostatic proportional controlLocal and remote overtemp notification, with local display110V input voltage

The UNI Series laser-cut connector panels feature knockouts designed to accept a number of connectors, including XLR and Neutrik. The innovative design allows mounting of both male and female connectors to the same holes simply by knocking out the correct pattern. Made from one-piece flanged steel, black powder coat finish.

Universal mounting pattern holds Extron® and other small devices

The UD Series drawers offer an economical rack storage solution. Full extension ball bearing slides extend a full 14” to reveal inside dimensions measuring 15-7/8” wide by 14-1/2” deep. Each model comes with a face formed drawer pull. User-installed latch and keylock are available options. Black powder coat finish.

Works with UFA Series shelves “Universal Face-After” shelves designed to mount small items conveniently in the front or rear of a rack while providing outstanding cable management and small device tie down points. These shelves feature the unique ability to mount a faceplate after the shelf is installed and populated, providing an attractive and secure covering.

The VWM Split Solid Doors provide both integrator and end user access to keep your systems secure.

Universal mounting pattern holds Extron® and other small devices