Showing 0–10 of 136 results

Network switches, load balancers, and routers typically sit at the top and back portion of the rack. This placement makes it difficult for cold air to travel from the front of the rack to the air intakes of the network switch equipment, increasing chances of failure over time. SwitchAir helps prevent failure by channeling cool air from the front of the rack to the air intakes regardless of where the equipment is mounted.

Pair of full height 19” EIA mounting rails, accepts cage nuts, U markings on front and rear of each rail.Depth markings included on frame for easy alignment.Accessory mounting holes along rails allow for mounting of cable management fingers and tool-less accessories.Rectangular cutouts for routing cables through 800mm (31.5”) wide 19” EIA rails from front to rear or for airflow for side breathing equipment.

Tool-less removeable top panel.Integrated hole pattern for easy installation of top panel accessories (cable management, modular busway support brackets, ladder / cable tray support brackets).Four cable entry holes allowing for up to 2000 Cat6 cables, or 60A PDU plugs.Top Panel load capacity of 150 lbs.

Tool-less removeable top panel.Integrated hole pattern for easy installation of top panel accessories (cable management, modular busway support brackets, ladder / cable tray support brackets).Four cable entry holes allowing for up to 2000 Cat6 cables, or 60A PDU plugs.Top Panel load capacity of 150 lbs.

The DCE Rack System has been designed to meet the flexibility, ease of installation, and delivery requirements needed by today’s data centers. Choose from either the pre-configured rack selections or choose from our numerous factory installed accessories and configurations to customize your rack the way you need it, when you need it.

This mounting kit for 2-post racks used in telecom sites is covenient when flush type mounting is required for 23'' wide tacks

"1/4 Turn Tool-less Cable Management Lobster Claw offers the ultimate in flexibility in cable management for moves, adds, and changes. Lobster claws install on 19"" vertical mounting rails without taking up U space. Claw can also be installed on PDU/cable management rails. Color: black."

Vertiv VRA6021 rack accessory Blank panel

This mounting kit for 2-post racks used in telecom sites is covenient when fush type mounting is required for 19'' wide tacks

Network switches, load balancers, and routers typically sit at the top and back portion of the rack. This placement makes it difficult for cold air to travel from the front of the rack to the air intakes of the network switch equipment, increasing chances of failure over time. SwitchAir helps prevent failure by channeling cool air from the front of the rack to the air intakes regardless of where the equipment is mounted.